This is how I made these gorgeous enameled cufflinks.

10007031_10152017784107654_594769571_n

So I started with a sheet of sterling silver 2.5mm thick and then I covered it in masking tape so that I could mark the circle shapes that I needed to cut out.

1959945_10152017775147654_155996242_n 14546_10152017775512654_583839651_n 1947502_10152017775907654_412448723_n

For the backs I used small circles and for the cufflink fronts I used larger circles.  I cut these out with a piercing saw using a 2.0 blade.

1970752_10152017776632654_1879607716_n  Here are the pieces for one set of cufflinks cut from the silver sheet.

After I had cut each disk out I soldered the silver wire detail onto the large disks using enameling solder.  After soldering and pickling these pieces I domed them slightly.

10151125_10152017776972654_981903868_n

I joined each large disk with a small one using 2.5mm thick wire cut to 1.7mm in length.  I soldered these on using enameling solder as they needed to withstand the high temperatures involved in enameling later.

1979676_10152017777347654_96811950_n1457547_10152017779102654_553066571_n

Once the cufflinks were soldered I pickled them and then cleaned them up. I also gave them a bit of a polish, ready for enameling.

1452193_10152017779567654_274495005_n

These are the cufflinks polished up and positioned on a homemade trivet waiting to be enameled.

1962855_10152017781057654_138298751_n

I use vitreous enamel which comes as a powder. The powder requires washing using distilled water and then final grinding in a mortar and pestle. I then applied the enamel using a fine paintbrush, taking care to keep the grains of enamel powder even and not too thickly spread.  The cufflinks then went into the kiln for three firings.  Each firing was about 2 mins and in between firings I let the cufflinks cool naturally on top of the kiln which stops the enamel from cracking.

10150773_10152017782067654_455222157_n 10154160_10152017781762654_1863391196_n 10006602_10152017781472654_817359965_n 1979613_10152017781592654_818925173_n

The enamel goes through many colour changes as its cools and so it is always recommended to test the enamel on scrap silver first.

1554460_10152017781262654_1223843813_n 1970448_10152017782297654_93628471_n

Once I was happy with the depth of colour on the enamel I cooled the cufflinks and then pickled them.  The enamels I used were safe to use in pickle, but its a good idea to check first as you dont want to ruin your work at this stage!

1609557_10152017780447654_1898669468_n 1458510_10152017782567654_729317251_n

After pickling the cufflinks I gave them a final polish and they were ready to be packaged up and sent off to their new owner. I also made a matching set of earrings to go with this pair.

1920634_10152017783182654_1068806715_n